NEC XL-6500G - Manual (Page 45)

45
S o u r c e R e g i s t r y
1 . I N P U T A
2 . S i g n a l
3 . H D T V
4 . U s e r N a m e
5 . N o . S e l e c t S i g n a l S y s t e m
< P r e v N e x t > C a n c e l
2 . S i g n a l S y s t e m
R G B
C - V i d e o
S - V i d e o
C O M P O N E N T
S o u r c e R e g i s t r y
1 . I N P U T A
2 . C O M P O N E N T
3 . H D T V
4 . U s e r N a m e
5 . N o . I s S i g n a l H D T V ?
< P r e v N e x t > C a n c e l
3 . H D T V
Y e s
N o
S o u r c e R e g i s t r y
1 . I N P U T A
2 . C O M P O N E N T
3 . H D T V M o d e
4 . U s e r N a m e
5 . N o . I n p u t U s e r N a m e
< P r e v N e x t > C a n c e l
4 . U s e r N a m e
[ ]
4) To Input a User Name.
Input the source name by selecting one character at a time with
the INPUT buttons 1 through 10 and by moving the cursor with
the CURSOR button. After finishing the selection of the
characters, press ENTER.
• Up to eight characters can be selected.
• Eight characters are assigned to one INPUT button.
• Whenever the INPUT button is pressed, characters will be
rotated.
When using with two or more ISS-6020/ISS-6020G switchers:
Use the CURSOR or button to select the input slot number of
the master Switcher and press ENTER. Then select the slot
number of the slave Switcher and press ENTER.
• The “MASTER” menu will be displayed when the slot
number of the master Switcher is selected.
• The “SLAVE” menu will be displayed when the slot number
of the slave Switcher is selected.
• The “4. User Name” screen will be displayed when you finish
entering the slot number.
2) To Select Signal System
Select your desired signal system.
Items to select
• RGB --------------- Selects the RGB input signal of this
projector
• C-Video ----------- Selects the VIDEO input signal of this
projector
• S-Video ----------- Selects the S-VIDEO input signal of this
projector.
• COMPONENT ---- Selects the component input signal of
this projector.
3) To Set HDTV or not When Selecting Component Signal.
When you select COMPONENT, you are asked if the compo-
nent is HDTV or not.
Select Yes or No according to your component source.
3.OPERATION