NEC XL-6500G - Manual (Page 53)

53
■ Registering Passcode
When the projector is shipped from the factory, no passcode is
registered. If you want to use the passcode option, you must register
a passcode.
To register a new passcode, proceed as follows:
1 Press the ADJUST button.
• The “Adjustment” menu will be displayed.
2 Use the CURSOR or button to highlight the “8.Set Option”
menu. Press ENTER to display the Set Option menu.
3 Use the CURSOR or button to highlight the “1.Passcode”
line. Press ENTER to display the “Passcode Setting” menu.
4 Use the CURSOR or button to select “Entry”. Press
ENTER to display the “New Passcode?” menu.
5 Enter a four digit passcode using the “1” through “10” buttons.
1) Each time you press the INPUT button, an asterisk will appear
next to the “New Passcode?” message.
NOTE: “0000” and “9999” cannot be used as a passcode.
2) Once you have finished entering your four digit passcode,
press ENTER to store the code.
NOTE: If you have made an error, press the NORMAL button
to delete the asterisk “✻”. Then re-enter the correct passcode.
To delete all the entered digits, hold down the CTL button
then press the NORMAL button.
3) If the passcode has been entered correctly, the “Confirm New
Passcode?” menu will be displayed.
NOTE: If the passcode is not entered correctly, the “Warning
Passcode!!” message will be displayed. You will be required
to enter the passcode correctly.
- A d j u s t m e n t -
1 . S o u r c e R e g i s t r y
2 . A m p l i t u d e
3 . W h i t e B a l a n c e
4 . S i g n a l L e v e l
5 . U n i f o r m i t y
6 . D i s p l a y F u n c t i o n
7 . L a m p M o d e
8 . S e t O p t i o n
- S e t O p t i o n -
1 . P a s s c o d e
2 . S e t t i n g M o d e
3 . M e n u M o d e
4 . E x e c u t e M o d e
P a s s c o d e
P a s s c o d e S e t t i n g
E n t r y D i s a b l e
P a s s c o d e
P A S S C O D E S E T T I N G
E N A B L E D I S A B L E
P a s s c o d e S e t t i n g
N e w P a s s c o d e [ ] ✳ ✳ ✳ ✳
3.OPERATION