NEC XL-6500G - Manual (Page 71)

71
Execute Mode
Enables you to select connecting with the switcher ISS-6020 and
view the projector address on the screen.
To do, follow the steps below.
1. Press the ADJUST button to display the Adjustment menu.
2. Use the CURSOR or button to select “8. Set Option” menu.
Press ENTER.
3. Use the CURSOR or button to select “4. Execute Mode”
menu. Press ENTER.
Proceed to the following steps.
This setting explains how the projector is used with the ISS-6020/
ISS-6020G Switcher.
1 Use the CURSOR or button to select the “1. Connect
Condition” item, then press ENTER to display the ““1. Connect
Condition” menu.
2 Use the CURSOR or button to select your desired connec-
tion condition of Switcher and press ENTER.
• The “Re-Start ?” prompt is displayed after setting of the connec-
tion condition is modified from the current status to your desired
condition.
Items to select
• Stand Alone ......... The projector used in stand alone operation.
• SW 1 Level .......... The projector used with one Switcher.
• SW 2 Level .......... The projector used with two or more
Switchers.
■ Connect Condition
- E x e c u t e M o d e -
1 . C o n n e c t C o n d i t i o n
2 . P J A d d r e s s
E x e c u t e M o d e
C o n n e c t C o n d i t i o n
P J A d d r e s s [ 0 1 ] ( 0 1 - 6 4 )
[ S t a n d A l o n e ]
3 Use the CURSOR or button to select either “Yes” or “No”
and press ENTER.
Items to select
• Yes .......... Restart the projector.
• No ........... Does not restart the projector.
NOTE: The selected connection condition becomes effective
only after the projector is restarted.
R e - S t a r t ?
Y e s N o
Connect Condition
Stand Alone
SW1 Level
SW2 Level
3.OPERATION