NEC XL-6500G - Manual (Page 67)

67
There are two modes of operations for the on-screen display. With
AUTO mode, the on-screen display will automatically switch off
after three through ten seconds. In the MANUAL mode, the display
must be manually turned off with the DISPLAY button on the full
function remote control each time it appears.
NOTE: Pressing DISPLAY with CTL will select the non on-screen
mode; pressing DISPLAY with CTL again will cancel this mode.
Even if the on-screen display may be turned off with CTL and
DISPLAY, any adjustment will still change the projector’s memory
settings.
Proceed as follows:
1 Use the CURSOR or button to highlight the “Message
Time” item.
Press ENTER to display the “Message Time” menu.
Menu Mode
Enables you to set various items for on-screen display.
To do, follow the steps below.
1. Press the ADJUST button to display the Adjustment menu.
2. Use the CURSOR or button to select “8. Set Option” menu.
Press ENTER.
3. Use the CURSOR or button to select “3. Menu Mode”
menu. Press ENTER.
Proceed to the following steps.
This feature allows you to display the items on the top of the
screen: date, time, input signal, source name, address, and new
signal.
■ Message Time
- M e n u M o d e -
1 . M e s s a g e T i m e
2 . D a t e , T i m e P r e s e t
3 . D i s p l a y I t e m S e t
M e n u M o d e
M e s s a g e T i m e
D a t e , T i m e P r e s e t
D i s p l a y I t e m S e t
D a t e [ O f f ]
[ O f f ]
[ O f f ]
[ O f f ]
[ O f f ]
[ O f f ] N e w S i g n a l
T i m e
I n p u t S i g n a l
S o u t c e N a m e
A d d r e s s
[ A u t o 1 0 S e c ]
J a n / D D / Y Y Y Y
H H : M M : S S
3.OPERATION