Riverstone Networks RS 2100 - Manual (Page 42)

4-2 Riverstone Networks RS 2100 Switch Router Getting Started Guide
Powering on the RS 2100 RS 2100 Initial Configuration
Here is a partial example:
4. When the software is fully booted, the following messages appears on the management console:
Boot Software Version prom-2.0.0.5, Built Jan 5 2001 20:18:57
Processor: R5000 rev 2.1 [0x2321], 160 MHz, (bus: 80 MHz), 128 MB DRAM
I-Cache 32 KB, linesize 32. D-Cache 32 KB, linesize 32.
Mounting 16MB flash card . . . Done
Autoboot in 2 seconds - press ESC to abort and enter prom
using link: bootsource
link pointed at file:/pc-flash/boot/rs70/
source: file:/pc-flash/boot/rs70/
Loaded version file
Loading kernel (base 0x80001000, size 50592)
(base 0x8000d5a0, size 2658597)
100% - Image checksum validated
----------------------------------------------------------------------
RS 2100 System Software, Version 7.0.0.0
Copyright (c) 2000-2001, Riverstone Networks, Inc.
Built by mhaydt@diego on Mon Jan 5 17:10:42 2001
Processor: R5000, Rev 2.1, 159.99 MHz
System started on 2001-10-01 15:27:01
----------------------------------------------------------------------
2001-10-01 15:27:02 %SYS-I-FLASHCRD, Mounting 16MB Flash card
2001-10-01 15:27:06 %SYS-I-FLASHMNTD, 16MB Flash card mounted
2001-10-01 15:27:06 %SYS-I-INITSYS, initializing system RS 2100
2001-10-01 15:27:06 %SYS-I-DSCVMOD, discovered 'Control Module' module in slot CM
2001-10-01 15:27:11 %SYS-I-INITSLOTS, Initializing system slots - please wait
2001-10-01 15:27:18 %SYS-I-MODPROBE, Detecting installed media modules - please wait
2001-10-01 15:27:23 %SYS-I-INITPORT, initialized slot CM/1, port 1
2001-10-01 15:27:23 %SYS-I-INITPORT, initialized slot CM/1, port 2
2001-10-01 15:27:23 %SYS-I-INITPORT, initialized slot CM/1, port 3...
Press RETURN to activate console...