Riverstone Networks RS 2100 - Manual (Page 72)

A-2 Riverstone Networks RS 2100 Switch Router Getting Started Guide
Configuration changes are not reinstated
after a reboot. To save the configuration changes to the Startup
configuration file, use the procedure in
Section 4.3.2, "Saving the Active Configuration to
the Startup Configuration File."
The RS 2100 is not resolving DNS names. To set up DNS, use the procedure in Section 4.7,
"Setting the DNS Domain Name and Address."
If you have already performed this procedure, make
sure you can use NS lookup on the DNS server to get
the default domain.
An SNMP manager cannot access the
RS 2100. To set up an SNMP community string and specify a
target for SNMP traps, use the procedure in
Section 4.6, "Setting Up SNMP."
If you have already performed this procedure, type
snmp show all
in the CLI to check the SNMP
settings.
Use the
traceroute
and
ping
commands to verify
that the RS 2100 can reach the SNMP management
station.
You are unable to ping a certain host. Create and add an IP or IPX interface for the host.
See the
Riverstone Networks RS Switch Router User
Guide for information.
Table A-1 Troubleshooting (Continued)
If you experience this difficulty Try this remedy