Roland MOBILE CUBE - Manual (Page 11)

Español
Itali
ano
Franç
ais
Deutsch
English
Por
tug
uê
s
Ne
derla
n
ds
11
Using a Microphone Stand
By using a microphone stand, you can mount the
MOBILE CUBE at the optimal height for use as
a monitor speaker or simple PA device.
The microphone stand holder supports
a diameter of either 3/8 inch or 5/8 inch.
If you’re using the MOBILE CUBE with a 5/8
inch microphone stand, remove the microphone
stand adaptor from the bottom of the unit.
* If you’re not using a microphone stand, be sure to attach the
microphone stand adaptor to prevent leakage of sound (air).
928
* When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
929
* When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
Requirements when using
a microphone stand
As shown in the illustration below, you must use
a microphone stand that will be no higher than
125 cm (including the MOBILE CUBE), and
whose legs can be opened to a maximum width of
63 cm or more.
* Using a microphone stand that does not meet the
specifications above may result in damage to equipment or
injury due to the stand tipping over.
* When using MOBILE CUBE with a microphone stand, the
microphone stand must be carefully placed so it is level and
sure to remain stable.
* Cables connected to MOBILE CUBE should be given
enough slack to prevent accidents that might result from
someone tripping over them.
* To prevent accidents due to falls, do not place any object on
the MOBILE CUBE when it’s mounted on a microphone
stand.
* After attaching the MOBILE CUBE to the microphone
stand, check to make sure that it is stable before you use it.
Microphone stand adaptor
125 cm (49-1/4”)
or less
63 cm (24-13/16”) or more
MOBILE_CUBE_egfiepn.book Page 11 Wednesday, March 5, 2008 10:35 AM