Roland KR-17 - Manual (Page 85)

85
Chapter 3 Song Playback
Chapter 3
Using the Remote Control
(Only for Instrument Equipped with CD Drive)
You can use the included remote control to easily start and stop performances and
switch songs.
■ Installing Batteries in the Remote Control
Install the batteries provided in the remote control.
1.
Open the battery cover on the back of the remote control.
2.
Insert the supplied AA batteries, as shown in the figure of remote
control.
3.
Close the battery cover.
■ How to Use the Remote Control
When using the remote control, aim the remote control at the infrared receiver,
keeping in mind the range of operation (below).
Precautions Concerning Use of the Remote Control
• The remote control is able to transmit only one operation at a time.
• The remote control may not operate even within the range of operation if there
is an obstacle between it and the main unit.
• Using the remote control near other equipment that uses remote control systems
may result in operational errors.
• The life of the battery depends on the amount and conditions of use. If the
operational range of the remote control decreases, change the batteries.
• If you will not be using the remote control for a long period of time, remove the
batteries.
NOTE
No remote control is included
with models that are not
equipped with a CD drive.
NOTE
Be careful to observe
the correct polarity (+, -
direction) when installing
the batteries.
CD Drive
Remote Control
Infrared Receiver
Range of operation
Distance:
4 m (approximately 13 feet)
Angle:
30 degrees to the left and right
of the receiver.
KR-17_15_e.book 85 ページ ２００４年１２月６日 月曜日 午後１時５４分