Roland AT900C - Manual (Page 276)

274
Troubleshooting
The sound is not played correctly
If you layer the same type of sound (for
example, Strings 1 and Strings 5), or
play an octave-shifted organ sound,
the timing at which you play a note or
the phase relationship between the two
sounds may affect the way in which the
sounds are heard, but this is not a
malfunction.
You are layering sounds of the same
type (e.g., Strings 1 and Strings 5).
Alternatively, you are playing an
organ sound with Octave Shift.
This is not a malfunction.
- - -
Lyrics are not indicated properly
in the display
With some music files, the lyrics cannot
be displayed correctly.
This is not a malfunction. - - -
In the Notation screen, some lyrics or
notes could extend beyond the edges
of the screen, and not be displayed.
This is not a malfunction. - - -
A button was pressed while the lyrics
were being shown in the display.
During the display of lyrics, you could
be taken to a different screen if you
press a button.
If you want to have the lyrics be
displayed again, touch <Play> on the
Rec/Play screen.
p. 164
The Touch Screen doesn’t respond
correctly
The positioning of the Touch Screen
may become displaced if some time
has passed since it was last used
Reposition the Touch screen. p. 229
Certain instrument are not heard
while playing a song
The track is muted. Turn off track muting.
p. 168
p. 170
Can’t use Chord Intelligence
function
Chord Intelligence is at OFF. Turn “Chord Intelligence” on. p. 90
Notation is not indicated properly
in the display
In the Notation screen, some lyrics or
notes could extend beyond the edges
of the screen, and not be displayed.
This is not a malfunction. - - -
The Notation display feature is
particularly unsuitable for the display
of difficult, complex musical works that
demand accurate notation.
This is not a malfunction. p. 173
If you select a part that does not
contain performance data, notes will
not be displayed in the notation.
Change the part that is displayed. p. 172
The Bass Range Sounds Odd, or
There Is a Vibrating Resonance
Playing at loud volumes may cause
instruments near the ATELIER to
resonate. Resonance can also occur
with fluorescent light tubes, glass
doors, and other objects. In particular,
this problem occurs more easily when
the bass component is increased, and
when the sound is played at higher
volumes.
Use the following measures to suppress
such resonance.
• Place speakers so they are 10-15 cm
from walls and other surfaces.
• Reduce the volume.
• Move the speakers away from any
resonating objects.
- - -
When listening through headphones:
Here, a different cause (such as
resonance produced by the ATELIER)
would be suspect.
Consult your Roland dealer or nearest
Roland Service Center.
- - -
Problem Check Solution Page
AT-900_e.book 274 ページ ２００７年９月７日 金曜日 午前８時４３分