Roland AT900C - Manual (Page 60)

58
Selecting and Playing Sounds
Using the Harmonic Bar Settings of the Panel
If you’ve edited the harmonic bar settings in the screen, or if you’ve switched
registrations so that the Vintage Organ settings have changed, you can switch
the Vintage Organ settings to the positions (settings) of the harmonic bars on
the panel (p. 54).
1.
Press the H-Bar [Manual] button.
When you press the Vintage Organ button, a vintage organ screen like the
following will appear.
There are two types of vintage organ screens.
Vintage Organ Screen
When the Vintage Organ Type is “Flute”
fig.01-24.eps
The screen will show the harmonic bars.
By touching the harmonic bars and sliding them, you can adjust the volume of
each footage. The volume can be adjusted over nine steps (0–8).
When a harmonic bar is pulled out all the way (8), the volume is loudest.
When it is pushed in all the way (0), there will be no sound.
Icon Explanation
Vib (Vibrato) Adds a vibrato effect to the sound.
Cho (Chorus) Adds a chorus effect to the sound.
U/L/P
Touching the icon cycles you through the available choices,
which are: Upper Vintage screen, Lower Vintage screen, and
Pedal Vintage screen.
Hold
The Vintage Organ screen will automatically close after it has
been displayed for several seconds. If you touch <Hold>, the
screen will remain displayed until you touch <Hold> once again.
The Vintage Organ screen will
be displayed for several
seconds, then it will close
automatically.
If you touch <Hold>, the screen
continues to be displayed until
you touch <Exit>. When you
touch the Vintage Organ screen
and then change the settings,
the screen is held in that
condition.
By touching the screen and
sliding your fingertip to the left
or right (horizontally), you can
adjust the volume of all
harmonic bars.
NOTE
It is not possible to apply both
vibrato and chorus
simultaneously.
You can touch < >
to switch between the Upper
Vintage Organ screen, Lower
Vintage Organ screen, and
Pedal Vintage Organ screen.
AT-900_e.book 58 ページ ２００７年９月７日 金曜日 午前８時４３分