Raymarine hsb2 PLUS Series - Manual (Page 136)

5-38 hsb 2 PLUS Series LCD Display
Us
in
g T
rac
ks
5.7 Using Tracks
The Track function is used to mark on-screen the trail that your vessel has
followed, as if it had left a visible fixed wake.
While the track is switched on it is recorded in the display unit’s memory. You
specify the interval at which track points are made and a line is drawn on-
screen between each point. Up to 4500 track points can be saved in total: in the
current track and in up to 5 track files (each a maximum of 750 points). The
current track remains on-screen, even following a power off/on, until you
clear the track.
Breaks in the track will be caused when the display unit is switched off or
either of the following occur for longer than the specified track interval: the
track is switched off then on; the position fix is lost.
To enable you to follow this track on your return voyage, the SmartRoute
function converts the track (or the last segment of a track with breaks) into a
route which is automatically reversed, see SmartRoute on page 5-42.
A track can be saved and retrieved for display at a later date. You can only
display one track at a time; you must clear a current track from the screen if
you want to display a saved track.
This section describes:
• Setting up a track, including how to specify the interval.
• Clearing the current track.
• Managing tracks, using the track list, including Saving, Naming, Erasing
and Showing a track.
• Making a Track into a Route
➤ To access the track controls:
1. From the chart display, press the MENU key to display the chart set up soft
keys.
2. Press the TRACK SETUP soft key to display the Track soft keys:
The following instructions assume you have the track soft keys displayed.
D4162-1
SYSTEM
SET UP¬
CHART
SET UP¬
TRACK
SET UP¬
GPS
SETUP¬
D5674-1
TRACKS
OFF ON CLEAR
TRACK MAKE INTO
ROUTE MORE¬
81186_3.book Page 38 Thursday, August 22, 2002 8:23 AM