Revox M10 - Manual (Page 14)

M10 Re:system
13
LED red – flashing quickly
A) Temperature is too high
There is overheating in the M10
housing. The maximum permitted
temperature value has been
exceeded even though the fan is
active.
Countermeasure(s):
- Check the installation
environment
- Check the ventilation slots
- Check the fan
B) Power levels are too high
The permitted power value has
been exceeded at one or more of
the internal M10 power units.
Countermeasure(s):
Check the connected cables (M-
Link, USB, etc.) for short circuits.
Are all modules inserted correctly
in the M10?
C) Software problem
There is a fault in the data traffic.
Countermeasure(s):
- Carry out a firmware update
- Check the modules. Is the module
type and its software correct for
each slot?
LAN Ethernet connection
A connection to an Ethernet LAN
can be established through the
RJ45 socket. The Ethernet
interface is configured manually
during the M10 setup. DHCP
functionality is not supported.
The two LEDs integrated in the
RJ45 socket indicate the status of
the data connection.
The Revox Multiroom System can
be controlled through the
Ethernet interface. Either through
the Revox Service programs, e.g.
M230 or the primary domestic
control system, e.g. GIRA Home
Server.
There is a very flexible UDP
protocol available for domestic
control system programmers.
Further information about this
clear-text protocol can be found
under www.revox.de
A maximum of 10 Clients can
have parallel access to the M10.
The MAC address is noted on the
bottom of the M10.
You will find further documen-
tation about the Ethernet interface
starting from Page 16.