Revox M10 - Manual (Page 23)

M10 Re:system
22
IP Address ➮ [ ]
The 4 blocks of the IP address that
the M10 should have are set using
the two Address softkeys.
In a network of DHCP-enabled
LAN Clients, you must always
ensure that these are not given the
M10’s IP.
IP Subnet Mask ➮ [ ]
The 4 blocks of the IP Subnet that
the M10 should have are set using
the two Mask softkeys.
Default Gateway ➮ [ ]
The 4 blocks of the Default
Gateway that defines the external
access in the Internet are set using
the two Gateway softkeys. If such
a data exchange is required
outside the LAN, the Default
Gateway must be configured in
compliance with the local
requirements.