Revox M10 - Manual (Page 22)

M10 Re:system
21
CLIENT LIST
The CLIENT LIST shows all
devices that are currently
accessing the M10. Up to 10
clients can have parallel access.
If no client is logged on, four zeros
appear in the corresponding line.
In the example below, three
clients are accessing the M10.
The IP address of each client is
shown.
Using the menu softkey, you can
toggle between the CLIENT LIST
menu page and the two TCP/IP
pages.
The Access Point required for the
radio transmission does not appear
with its IP address in the CLIENT
LIST.
Page TCP/IP
The base settings for the Ethernet
access are set through the two
TCP/IP pages.
The setting is made by selecting
the corresponding address block
with the softkeys, which is then
shown in square brackets
192.[168].0.6
Now the required setting can be
made using the two display keys
Jog [+ / -].
The new settings are confirmed
with the Apply softkey. Otherwise
the previous setting is retained.
Note
All settings in the M10 setup are
made using the Jog [+/-] keys.
The following symbol additionally
draws your attention to it in the
manual: [ ]