Raymarine C90w - Manual (Page 29)

Digital radar cables
You will need at least 2 cables to connect the digital radar scanner.
One cable connects the scanner to a SeaTalk
hs switch (or cross
over coupler). The second cable then connects into the display.
Note: The maximum cable length including all extensions is 25 m
(82 ft).
Radar scanner to SeaTalk hs switch (or cross over coupler)
Digital scanner cables
Connect the Radar scanner to the SeaTalk
hs switch (or cross over coupler) and
power supply. These cables contain both power and data wires.
Cable Part number Notes
5 m (16.4 ft) Digital cable A55076
10 m (32.8 ft) Digital
cable A55077 Your radar scanner may
include the 10 m cable
(depending upon the
model purchased)
15 m (49.2 ft) Digital
cable A55078
25 m (82.0 ft) Digital
cable A55079
Extension cables
Use of one of these cables to extend the radar connection to the SeaTalk
hs switch
(or cross over coupler) and power supply. These cables contain both power and
data wires.
Cable Part number Notes
2.5 m (8.2 ft) extension
cable A92141
5 m (16.4 ft) extension
cable A55080
10 m (32.8 ft) extension
cable A55081
SeaTalk hs switch (or cross over coupler) to display unit
SeaTalk hs network cables
Connect from the SeaTalk hs switch or the cross over coupler into the rear of the
display.
Cable Part number Notes
1.5 m (4.9 ft) SeaTalk hs
network cable
E55049
5 m (16.4 ft) SeaTalk hs
network cable
E55050
10 m (32.8 ft) SeaTalk hs
network cable
E55051
20 m (65.6 ft) SeaTalk hs
network cable
E55052
SeaTalk hs hardware
To connect the digital radar to the C-Series display you will need
to include one of the following
Cables and connections 29