Radio Shack 43-3823 - Manual (Page 20)

The Integrated Answering Device
20
Setting the Time
The clock on the answering system starts when
power is supplied to the base. Follow these steps to
set the clock to the correct time. Ô
1. Press clock/menu .
The system announces “Time”, the current time
and the guidance for setting the time.
2. Press SELECT/VOLUME/ or SELECT/VOLUME/
until the correct day is announced. The
numbers [ ] through [ ] are displayed on the
base.
3. Press set to select the day.
4. Press SELECT/VOLUME/ or SELECT/VOLUME/
until you hear the correct hour setting. The
numbers [ ] through [ ] are displayed on the
base as each hour is announced.
5. Press set to select the hour.
6. Press SELECT/VOLUME/ or SELECT/VOLUME/
until you hear the correct minute setting. The
numbers [ ] through [ ] are displayed on the
base as each minute is announced.
7. Press set to select the minute.
8. Press SELECT/VOLUME/ or SELECT/VOLUME/
until you hear the correct AM or PM setting.
The message counter displays [ ] or [ ].
9. Press set to select the AM/PM setting.
You hear a confirmation tone, then the
announcement “Time” and the time and day are
announced for your review. After a few seconds,
the system announces “To set security code, press
menu again”.
Ô
NOTE
Ô
• Normally the idle time for
the menu mode is 10
seconds before the
system returns to
standby. However for
setting the time, the idle
time is extended to two
minutes.
• Press and hold SELECT/
VOLUME/ or SELECT/
VOLUME/ to quickly
scroll through the
numbers on the display.
43-3823.FM Page 20 Thursday, March 27, 2003 10:22 AM