Radio Shack 43-3823 - Manual (Page 8)

Installation
8
3. Insert the supplied AC adapter’s barrel plug
into the DC IN 9V jack on the back.
4. Route the adapter’s cord through the strain
relief slot on the base’s bottom.
5. Plug the adapter into a standard AC outlet.
6. Lift the base’s antenna to a vertical position.
On a Wall Plate or Wall
To mount the phone directly on a wall, you need
two screws (not supplied) with heads that fit into the
keyhole slots on the base. Drill two holes 3
15 /
16
inches apart. Thread a screw into each hole, letting
the heads extend about
1 / 8 inch.
1. Insert the two tabs at
the top of the narrow
end of the supplied
bracket into the base’s
upper tab slots, then
press down on the
bracket’s latches and
insert them into the
lower slots.
2. Plug one end of the supplied modular cord
(short for a wall plate, long for direct wall
mounting) into the
TEL LINE jack on the base’s
back.
3. Insert the
supplied AC
adapter’s barrel
plug into the
DC
IN 9V jack.
4. Route the
adapter and
modular cords
through the
base’s grooves.
TEL LINE
DC IN 9V
43-3823.FM Page 8 Thursday, March 27, 2003 10:22 AM