RCA B27TF680 - Manual (Page 29)

Chapter 2 27
Using the Remote Control
You’ll use these buttons when
you program the remote to
operate another component.
Important: The remote might
not operate all models of all
brands. The remote buttons
also might operate differently
for other components,
especially when you’re using
their menu system.
ON•OFF
REVERSE PLAY
STOP
CH +
CH
VOL
VOL
VCR2 SAT•CABLE
TRACK -
TRACK +
Tip
To stop the automatic code search without
programming any components, press and hold
CLEAR until the light on the remote turns off.
SOUND Use this button to display available audio for the type of disc that is playing.
SPEED-ZOOM Use to zoom in on the picture when playing DVD discs.
STOP Stops disc play.
SKIP-TITLE Allows you to see the title and other options available on the current disc (if the
disc contains the options).
VIEW Allows you to switch to a TV program or a recording channel, if you are recording.
Programming the Remote to Operate
Other Components
The universal remote control can be programmed to operate most brands of
remote controllable VCRs, satellite receivers and cable boxes. The remote is
already programmed to operate most RCA, GE and Proscan VCRs and satellite
receivers.
Note: The TV, VCR, and DVD buttons cannot be programmed.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed, turn a
component ON, such as a VCR, point the remote at the VCR, and press the
VCR2 button. Then press ON•OFF or channel up or channel down to see if the
VCR responds to the remote commands. If not, the remote needs to be
programmed.
How to Program the Remote
There are two ways to program the remote control: automatic code search and
direct entry. Instructions for both ways follow.
Using Automatic Code Search
1. Turn on the component you want the remote to operate (VCR or satellite
receiver).
2. Press and hold the component button on the remote that corresponds to the
component you want the remote to operate (VCR2 or SAT•CABLE). While
you hold down the component button, press and hold ON•OFF (when the
light below the ON•OFF button on the remote turns on, release both
buttons).
(Steps continued on next page)