RCA B27TF680 - Manual (Page 30)

28 Chapter 2
Using the Remote Control
3. Press PLAY (the light on the remote starts flashing).
The remote is searching the first set of component codes (there are 20 sets of codes). If the
component you want to operate doesn’t turn off automatically after 5 seconds, press PLAY
again (the light starts flashing again as the remote searches through the next set of codes).
Continue pressing PLAY until the component turns off.
Note: If the component doesn’t turn off after you’ve pressed the PLAY button 20 times, the
component can’t be programmed.
4. Press REVERSE, wait 2 seconds. Repeat this step until the component turns back on.
5. To finish, press and hold the STOP button until the light on the remote turns off.
Using Direct Entry
1. Turn on the component you want the remote to operate.
2. Look up the brand and code number(s) for the component on the code list on the next
page.
3. Press and hold the component button (VCR2 or SAT•CABLE) that corresponds to the
component you want the remote to operate.
4. Enter the code from the code list on the next page.
5. Release the component button.
6. Press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try
pressing the component button and then ON•OFF again.
• If you get no response, repeat these steps using the next code listed for your brand, until
the component responds to the remote commands.
• If you try all the codes for your component brand and none work, try the automatic
code search method. If automatic code search doesn’t find the code, the remote is not
compatible with your component.
How to Use the Remote After You’ve Programmed It
Once the remote has been programmed successfully, you are ready to use it to control your
components. To operate the component:
1. Press the component button (VCR2 or SAT•CABLE) to set the remote to control the
component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Notes: If you keep pressing buttons and nothing happens, the remote is probably in the wrong
mode. You must press the component button that matches the component you want to operate (i.e.,
if you want to operate the satellite receiver, press SAT•CABLE on the remote to put it in the satellite
receiver mode).
The other remote buttons may operate differently for other components, especially when you’re
using their menu systems.
How to Order A New Remote Control
To order a new remote control or other accessories to use with your TV/VCR/DVD, go to
Accessories in Chapter 6.
Important
You must continue pressing the
component button while you
enter the code.