Raymarine Satellite TV Systems - Manual (Page 29)

25
System set up
Introduction
This section of the handbook describes how to set up your Raymarine
Satellite TV system after installation using the ACU or the Graphical User
Interface (GUI) and includes the following functions:
• System start up.
• Change the default satellite.
• Monitor the antenna status.
• Enter set up mode.
• Setting the satellite pair.
• Setting the GPS.
• Setting the local frequency.
• Setting the DiSEqC method.
• Display versions.
• Setting antenna go position.
• Setting antenna move step.
• Setting the default satellites.
Many of the above functions will only be required at initial installation of
your system.
Note: The satellite names shown on the ACU screen in the following
illustrations may differ from those on your ACU depending on your
geographic location.
Set up using the ACU
Start up
With the system installed and power applied, the ACU screen will show the
following sequence:
1. Communication is being estab-
lished between the antenna and the
ACU
2. The antenna is initialized.
3. The antenna is searching for Satel-
lite A.
4. The antenna has located the satel-
lite and is now tracking
D7964_1
INITIALIZE ACU
RAYMARINE 45STV
D7965_1
INITIALIZE ANTENNA
RAYMARINE 45STV
D7966_1
SEARCHING A: ASTRA2
B: HOTBIRD SETUP
D7967_1
TRACKING A: ASTRA2
B: HOTBIRD SETUP
81258_3.book Page 25 Wednesday, November 8, 2006 2:06 PM