Roland HP-201 - Manual (Page 12)

12
Before You Start Playing
Connecting the Pedal Cord
1. Connect the pedal cord to the Pedal connector on the
bottom panel of the HP201, at the rear.
fig.00-01
Connecting the Power Cord
1. Insert the included power cord into the AC inlet on
the bottom panel of the HP201, at the rear.
2. Plug the power cord into a power outlet.
NOTE
Be sure to use the supplied power cord.
fig.00-02
Opening/Closing the Lid
To open the lid, use both hands to lift it lightly, and
slide it away from yourself.
To close the lid, pull it gently toward yourself, and
lower it softly after it has been fully extended.
fig.00-05
NOTE
When opening and closing the lid, be careful not to let
your fingers get caught. If small children will be using the
HP201, adult supervision should be provided.
NOTE
If you need to move the piano, make sure the lid is closed
first to prevent accidents.
Setting Up the Music Rest
1. Insert the included music rest attachment screws into
the screw holes on top of the HP201, and tighten the
screws slightly.
fig.00-03
2. Put the music rest between the screws and the
HP201’s body.
3. While supporting the music rest with one hand,
secure it in place by turning the screws.
When attaching the music rest, support it firmly with one
hand to make sure that you don’t drop it. Be careful, so
you don’t get your fingers pinched.
4. To remove the music rest, support it with one hand
while loosening the screws.
After removing the music rest, don’t forget to retighten the
screws.
NOTE
Do not apply excessive force to the installed music rest.
NOTE
Be sure to use the supplied screws for attaching the music
rest.
NOTE
Before moving the HP201, be sure to remove the music
rest to prevent accidents.
HP201_e.book 12 ページ ２００７年２月２８日 水曜日 午前９時１０分