Roland HP-201 - Manual (Page 36)

36
Changing Various Settings
Remembering the Settings Even
when the Power is Turned Off
(Memory Backup)
Normally, the settings of the various variations will revert to
their default values when the power is turned off. However,
you can specify that the various settings will be remembered
even when the power is turned off.
This function is called “Memory Backup.”
Stored Settings
• Brilliance (p. 19)
• Dynamics (p. 19)
• Reverb On/Off, Depth of the Reverb (p. 21)
• Damper Resonance (p. 34)
• Key Off Resonance (p. 20)
• Key Touch (p. 22)
• Twin Piano Mode (p. 25)
• Master Tuning (p. 32)
• USB Driver (p. 40) *Stored when you make the setting
1. While holding down the [SONG] button and
[METRONOME] button, hold down the A0 key for
approximately five seconds.
The indicators of all buttons will blink several times. When
memory backup has been completed, the HP201 will
return to its previous state.
Restoring the Original Default
Settings (Factory Reset)
The memory backup settings can be restored to the original
default condition. This operation is referred to as “Factory
Reset.”
1. While holding down the [SONG] button and
[METRONOME] button, hold down the C8 key for
approximately five seconds.
2. When the indicators of all buttons start blinking,
switch off the power, then turn it back on again.
A0
Hold down for five seconds
C8
Hold down for five seconds
HP201_e.book 36 ページ ２００７年２月２８日 水曜日 午前９時１０分