Roland HP-201 - Manual (Page 13)

13
Before You Start Playing
Connecting Headphones
The HP201 has two jacks for plugging in headphones.
This allows two people to listen through headphones
simultaneously, making it very useful for lessons and when
performing piano pieces for four hands. Additionally, this
allows you to play without having to worry about bothering
others around you, even at night.
1. Plug the headphones into the Phones jack located at
the bottom left of the piano.
Connecting headphones will automatically mute the sound
from the internal speakers. The headphone volume is
adjusted by the [VOLUME] knob of the HP201 (p. 14).
fig.00-04.e
NOTE
Use Stereo headphones.
Some notes on using headphones
• To prevent damage to the cord, handle the headphones
only by the headset or the plug.
• Connecting the headphones when the volume of
connected equipment is turned up may result in damage
to the headphones. Lower the volume on the HP201
before plugging in the headphones.
• Listening at excessively high volume levels will not only
damage the headphones, but may also cause hearing
loss. Use the headphones at a moderate volume level.
■ Using the Headphone Hook
Whenever you are not using the headphones, you can hang
them on the headphone hook at the lower left of the HP201.
Attaching the Headphone Hook
Press and twist the headphone hook included with the HP201
into the hole in the bottom of the HP201 (refer to the figure
below). Turn the wing nut of headphone hook to secure the
headphone hook.
Turning the Power On and Off
NOTE
Once the connections have been completed, turn on
power to your various devices in the order specified.
By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other
devices.
1. To turn the power on, turn the [VOLUME] knob all
the way down, and then press the [POWER] switch.
The power will turn on, and the indicator of the [TONE]
button will light.
After a few seconds, you will be able to play the
keyboard to produce sound.
Use the [VOLUME] knob to adjust the volume.
NOTE
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
fig.00-06.e
Turning the Power Off
1. To turn the power off, turn the [VOLUME] knob all
the way to the left, and press the [POWER] switch.
The indicators for all buttons will go out, and the power
will turn off.
NOTE
If you need to turn off the power completely, first turn off
the [POWER] switch, then unplug the power cord from the
power outlet. Refer to “Power Supply” (p. 7).
Phones jack x 2
Headphone Hook
Wing Nut
Hole
HP201_e.book 13 ページ ２００７年２月２８日 水曜日 午前９時１０分