Renesas Emulation Probe M30850T2-EPB - Manual (Page 54)

M30850T2-EPB User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J1005-0200 Rev.2.00 April 1, 2007
2. Referring to the MCU Status
IMPORTANT
Notes on Selecting a Processor Mode:
z The MCU status is shown in “MCU Status” of the EMEM dialog box. Check that it is matching the specified
processor mode.
z Check that the RDY# and HOLD# are “H” level. If they are “L” level, as the MCU enters a wait status and the
emulator debugger cannot receive the signal from the MCU, an error is displayed.
Cancel Help
Referring to the MCU Status
It shows the status of each MCU pin. Check it to see if the
MCU status matches the selected processor mode. If a slider
of any pin is at the center, it means that the pin status is
indeterminate.
Page 54 of 98