RuggedCom RUGGEDBACKBONE RX1510 - Manual (Page 25)

RuggedBackbone™ RX1510
Installation Guide
Chapter 3
Installation
AC Power Supply Wiring 19
Section 3.2.4
AC Power Supply Wiring
Figure 42: Wiring for Single AC Power Supply (HIP module shown)
NOTE
• For 125/230VAC rated equipment, a appropriately rated AC circuit breaker must be installed.
• It is recommended to provide a separate circuit breaker for each power supply module.
• Equipment must be installed according to applicable local wiring codes.
Section 3.2.5
DC Power Supply Wiring Examples
+ +
Figure 43: Wiring for Two DC Power Supplies (24P or 48P modules shown)
NOTE
• For 125/230VAC rated equipment, a appropriately rated AC circuit breaker must be installed.