RuggedCom RUGGEDBACKBONE RX1510 - Manual (Page 38)

Chapter 3
Installation
RuggedBackbone™ RX1510
Installation Guide
32
Installing SIM Cards for GSM, EDGE, HSPA+ Cellular
Modems
Section 3.13.2
Installing SIM Cards for GSM, EDGE, HSPA+ Cellular Modems
NOTE
Be sure to take appropriate anti-static precautions before opening the cellular modem module.
1. Remove the module from the RX1510.
2. On the smooth side of the module, remove the four screws and remove the back of the module.
Figure 64: Cellular Modem Module Assembly:
W11 and W32 Single Antenna Modules
Figure 65: Cellular Modem Module
Assembly: W12 Dual Antenna Modules
3. Note the location of the SIM card cages. For modules W11 and W32, install the SIM card in SIM 1. For
module W22, install a SIM card in both SIM 1 and SIM 2.
4. Top open a SIM card cage, slide the silver catch down towards the antenna connector end of the module and
flip the cage open.
5. Hold the SIM card at its notched end, with its connectors facing down, and insert the SIM card into the cage.
6. Flip the cage down and slide the silver catch up away from the antenna connector end of the module.
7. Replace the back of the module and secure the back of the module with the four screws removed earlier.
8. Re-install the module in the RX1510.