Roland FP-3 - Manual (Page 33)

33
Chapter 3 Recording a Performance
You can easily record your performances.
You can play back a performance you have recorded to check what and how
you played, and play melodies on the keyboard along with prerecorded
accompaniment using the Rhythm.
Notes Regarding Recording
• Only one song can be recorded. With second or later recordings, the
previously recorded song is erased as the new material is recorded.
When recording a new performance, it is probably a good idea to erase
the previously recorded performance first (p. 37).
• Recorded performances are erased when the power is turned off.
Recording a Performance
This records only what you play on the keyboard, without using the Rhythm.
fig.03-01
1.
Press the [Song] button, getting its indicator to light.
The song number appears in the display.
2.
Press the [-] button to display the “USr.”
3.
Select the Tone to be played.
4.
If necessary, sound the metronome.
While listening the metronome, select the tempo and beat of the song (p. 23).
5.
Press the [Rec] button.
The [Rec] button’s indicator lights, the [Play] button’s indicator begins
flashing, and the FP-3 is put into recording standby.
6.
Press the [Play] button or play a key on the keyboard to
begin recording.
Press the [Play] button, and after two measures of count sound, recording
begins.
Recording will begin when you start playing the keyboard, even if you do
not press the [Play] button. In this case, a count is not sounded.
7.
Press the [Rec] button or the [Play] button to stop recording.
The indicators for the [Rec] and [Play] buttons are extinguished, and
recording stops.
Listening to the Recorded Performance
8.
Press the [Play] button.
Press the [Play] button again, and playback stops.
To Record Without Erasing
the Previously Recorded
Performance...
1st Pass
2nd Pass
The first Perform-
ance is preserved
7 4 5 6, 8 3 1 2
NOTE
When you record
additional material without
erasing the previously
recorded sounds, the song
is recorded at the initially
recorded tempo.
During the count-in, the
count measure is indicated
in the display as “-2” then
“-1.”
About “USr” in the
Display
When recording is stopped,
the “ ” indication
changes to “ ” in the
display. The “.” in the
display indicates that there
is Performance material
already recorded.