Roland FP-3 - Manual (Page 9)

9
Before You Play
2.
Connect the supplied AC adaptor to the FP-3, and then plug
its other end into a power outlet.
To prevent the inadvertent disruption of power to your unit (should the
plug be pulled out accidentally), and to avoid applying undue stress to the
DC In jack, anchor the power cord using the cord hook, as shown in the
illustration.
fig.00-02
3.
Connect the amp or audio gear to the Line Out jacks as
shown in the diagram.
In order to take full advantage of the FP-3’s sound we recommend that you
play it in stereo.
When using the system in mono, connect to the Line Out L (Mono) jack.
→If you are using headphones, refer to “Connecting Headphones” (p. 11).
→For instructions on connecting to the Pedal jacks, refer to “Connecting Pedals” (p. 10).
→For instructions on connecting to the MIDI connectors, refer to “Connecting MIDI
Devices” (p. 42).
Installing the Music Stand
fig.00-03
1.
Using the supplied screws, fasten the music stand to the
back of the FP-3 as illustrated.
Be sure to use the supplied screws for attaching the music stand.
Turn the screws clockwise to tighten them.
When attaching the music stand, support it firmly with one hand to make sure
that you do not drop it. Be careful, so you do not get your fingers pinched.
2.
To remove the music stand, support it with one hand while
loosening the screws.
Rear panel
DC In 9 V
Power
On Off
NOTE
Do not apply excessive
force to the installed music
stand.