Two vcrs, Copying and editing tapes, Editing tapes – RCA VR636HF User Manual
Page 38: Vcr channel, Recording, Using two vcrs for copying and editing tapes, Caution, Two vcr connection
36
RECORDING
Using Two VCRs for Copying and
Editing Tapes
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Connect the VCRs using the diagram below.
2. Turn on both VCRs and TV.
3. Tune the TV to the VCR viewing channel (either 3, 4, or TV’s
video input).
4. If you are using coaxial cables for the connection, tune
recording VCR to channel 3 or 4—the one selected on the
playback VCR.
If you are using audio/video cables, select L1 to record from
the jacks on the back or L2 to record from the jacks on the
front of the recording VCR.
5. Insert the tape you want to copy into playback VCR. Insert a
blank tape with its safety tab in place into recording VCR.
6. Use visual search to locate the segment you want to copy on
the playback VCR. Pause the tape at this location.
7. Press RECORD on the recording VCR, then PAUSE.
8. Press PAUSE on both VCRs to begin copying.
9. Press PAUSE on both VCRs to stop copying.
10. Repeat steps 6–9 to copy or edit additional segments.
Caution:
The unauthorized recording of
satellite broadcasts, television
programs, or other copyrighted
materials may infringe the rights
of others.
PLAYBACK VCR
CABLE BOX
OR ANTENNA
RECORDING VCR
OR
OR
TO TV
TO TV
3 CH. 4
ANT. IN
RF OUT
VIDEO
AUDIO
IN
OUT
L
R
3 CH. 4
ANT. IN
RF OUT
VIDEO
AUDIO
IN
OUT
L
R
IN
OUT
Two VCR Connection