Raritan Computer DOMINION DSX-0N-E - Manual (Page 139)

C HAPTER 12: C OMMAND L INE I NTERFACE 121
ssh/telnet.
port_range A block of contiguous IP addresses.
base_dpaip Sstarting value for the block of contiguous IP addresses.
IP address If IP Address = 0.0.0.0 is specified for a port, then the IP access is
disabled for that particular port. It is the same as unassigning the
IP address for a port.
dpa Command Example
The following example chooses the DPA IP mode IP:
admin > Config > Services > dpa mode IP
Note: When any changes are made over DPA mode and ports DPA configuration, the SX
device needs to be rebooted to apply new settings. DPA changes will not be available until
after the DSX is rebooted
After a successful DPA connection, the following appears:
ssh [email protected]
Password:
Authentication successful.
Starting DPA for port 1
Authentication successful.
Escape Sequence is: Control-]
You are now master for the port.
Enabling unauthorizedportaccess to a set of ports assigned to 'Anonymous' group.
Unauthorized port access is only available for configured DPA methods. Use the following
command:
admin > Security > LoginSettings > unauthorizedportaccess enable true
When unauthorizedportaccess is enabled it automatically Enables Anonymous group and the user
is able to configure it according to his requirement:
admin > Security > LoginSettings > unauthorizedportaccess
Unauthorized Port Access Settings:
Enable: 1
Group Settings:
Name: Anonymous
Class: Observer
Ports:
To configure Anonymous group settings go to config > user menu and execute the
following command: