Renesas Pod probe for M16C/1N Group M301N2T-PRB - Manual (Page 32)

M301N2T-PRB User’s Manual 3. Usage
REJ10J0037-0100 Rev.1.00 Mar.16, 2005 Page 30 of 48
3.4.2 If an Error is Detected in the Self-check
If the self-check does not result normally (system status error or target status error in Figure 3.5), check the following.
Whether the emulation pod and PC4701 are connected properly
Whether the pod probe and emulation pod are connected properly
Redownload the proper firmware
Whether the switches in the M30100T3-RPD-E and FLX64-PRB are set to the factory settings (as shown in Figure 3.3 and
Figure 3.4).
IMPORTANT
Note on Self-check:
If the self-check does not result normally (excluding target status error), the emulation pod may be
damaged. Then contact your local distributor.