RCA 360 User Manual
Page 15
1 SpeedTouch™ Installation
E-DOC-CTC-20031204-0011 v2.0
13
3
Windows will automatically recognize the THOMSON USB Remote NDIS device:
4
The Windows Found New Hardware Wizard appears:
This wizard will guide you through the installation procedure of the SpeedTouch™
USB drivers.
Click Next to continue.
5
The following windows of the Found New Hardware Wizard allow you to select
locations where it should search for drivers:
Insert the SpeedTouch™ Setup CD-ROM, make sure that the wizard looks for the
drivers on the CD-ROM drive and click Next to continue.
6
The wizard will notify that it found drivers for the THOMSON USB Remote NDIS
device on the CD-ROM.
Click Next to continue.
7
The installation procedure continues with the installation of the USB Remote
NDIS drivers.
8
In the following windows you can follow the installation procedure. Click Next
whenever requested to continue the installation.
9
At the end of the procedure, the following window appears:
Click Finish to complete the installation.
10
As a result your USB connection is installed and ready for use.