RCA 360 - Manual (Page 54)

4 Support
E-DOC-CTC-20031204-0011 v2.0 52
4.3 Resetting the SpeedTouch™
Reset to default
configuration
Proceed as follows:
1 Make sure the SpeedTouch™ is powered on (Power LED is solid green).
2 Use a pencil to press the recessed reset button ( D ) on the SpeedTouch™ rear
panel for at least six seconds until all the LEDs on the front panel turn off
3 As soon as all the LEDs on the front panel go off, release the reset button. This
indicates that the SpeedTouch™ is restarting in its default configuration.
Note Make sure to release the reset button as soon as all the LEDs have
gone off to prevent that the SpeedTouch™ enters BootP mode.
The SpeedTouch™ will come online again with default settings.
D