RCA 360 - Manual (Page 55)

4 Support
E-DOC-CTC-20031204-0011 v2.0 53
4.4 Troubleshooting
Configuration problems In case your SpeedTouch™ is unreachable due to misconfiguration, you might consider
a hardware reset to factory defaults as described in
“4.3 Resetting the SpeedTouch™”
on page 52 .
Troubleshooting table Following table may help you determine the nature of the problem, and provides some
plausible solutions:
Problem Solution
SpeedTouch™ does not work.
(none of the LEDs light up) Make sure that the SpeedTouch™ is plugged
into an power socket outlet.
Make sure that you are using the correct
power supply for your SpeedTouch™ device.
Make sure the power button on the Speed-
Touch™ is pushed in.
LAN LED does not light up.
Link integrity/Activity LED of
Ethernet port does not light up. Make sure that the Ethernet cable is securely
connected to the 10/100Base-T port.
Make sure that you are using the correct
cable type for your Ethernet equipment.
No Line synchronization achieved.
DSL LED off or flashing. Check whether the central splitter or dedi-
cated filters are installed correctly and that
the correct line is patched to your Speed-
Touch™ line port.
Make sure that ADSL service is enabled on
the telephone line the SpeedTouch™ is
connected to.
In case of ADSL/POTS (ADSL/PSTN)
services at your premises, ONLY use a
SpeedTouch™ ADSL/POTS variant.
In case of ADSL/ISDN services at your local
premises, ONLY use a SpeedTouch™ ADSL/
ISDN variant.
Bad regular telephone service Check whether a central splitter or dedi-
cated filters are installed properly.