Configuration of the speedtouch – RCA 360 User Manual
Page 44
4 Support
E-DOC-CTC-20031204-0011 v2.0
42
Configuration of the
SpeedTouch™
Proceed as follows:
1
Open a web browser and browse to the SpeedTouch™ web pages at
http://10.0.0.138
. See
“3 SpeedTouch™ Web Interface” on page 23
for more
information.
Note
If you can not access the SpeedTouch™ web pages, it is probably not in
its default state. It is recommended to reset the device.
2
The embedded
wizard will appear automatically:
Click Next.
Note
If
doesn’t start automatically go to
Basic > Easy Setup
.
3
The following window invites you to select the appropriate Virtual Channel for
the Bridged Ethernet Service:
4
Subsequent screens will guide you through the configuration setup of the Speed-
Touch™. Follow the instructions and enter the required information whenever
needed. The requested information will depend on the selected Service and
should be provided by your Service Provider.
Click Next whenever requested.