Roland TD-10 - Manual (Page 130)

Procedure
1. Press [PATTERN]-[F2 (FUNC)]-[F1 (GLOBAL)].
The “PATTERN GLOBAL” page will appear.
2. Use [CURSOR] to move the cursor to “Sync Mode.”
3. Use [INC/DEC] or the VALUE dial to select “External” or
“Auto.”
4. Begin playback on the transmitting device (master).
Synchronized playback will begin.
● Synchronizing an external
sequencer to the TD-10
In this case, the TD-10 will be the master. As shown in the
following diagram, use a MIDI cable to connect the MIDI
OUT of the TD-10 to the MIDI IN connector of the external
device.
fig.11-01e
Procedure
1. Press [PATTERN]-[F2 (SETUP)]-[F1 (GLOBAL)].
The “PATTERN GLOBAL” page will appear.
2. Use [CURSOR] to move the cursor to “Sync Mode.”
3. Use [INC/DEC] or the VALUE dial to “Internal” or “Auto.”
4. Make settings on the external sequencer so that it will
synchronize.
5. Press [PLAY] to start playback on the TD-10.
Synchronized playback will begin.
Sequencer
MIDI IN MIDI OUT
TD-10