Rangemaster 110 - Manual (Page 28)

28
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Conversion
All models are supplied set for use on group H natural gas.
A conversion kit for LP gas is included with the appliance.
See the instructions that are supplied with the conversion
kit. After converting the appliance please attach the Gas
Conversion sticker over the appropriate area of the data
badge, this will identify the gas type the appliance is now
set for.
This appliance is designed for domestic cooking
only. Use for any other purpose could invalidate
any warranty or liability claim.
You will need the following equipment
to complete the cooker installation
satisfactorily
STABILITY BRACKET
If the cooker is to be supplied
with gas through a fl exible hose,
a stability bracket or chain must
be fi tted.
These are not supplied by with the cooker but
are available at most builders’ merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance with
the relevant standards.
Because the space behind
the cooker is limited, we
recommend that a Micropoint™
connection hose and connector
is used.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1
. Electric drill
2
. Masonry drill bit (only required if fi tting the cooker
on a stone or concrete fl oor)
3
. Rawlplugs (only required if fi tting the cooker on a
stone or concrete fl oor)
4
. Steel tape measure
5
. Cross head screwdriver
6
. Flat head screwdriver
7
. Spirit level
8
. Pencil
9
. Adjustable spanner
10
. Screws for fi tting stability bracket
Checking the parts
3 pan supports
Griddle Wok stand
Grill pan and trivet 3 fl at oven shelves and 1 drop
shelf
Handyrack Meat tin
inner and outer plinths Levelling tool