Rangemaster 110 - Manual (Page 38)

38
WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
13. To Remove an Oven Door
Open the oven door. Loosen the two top hinge screws.
Support the weight of the door and remove the screw
nearest the hinge pin. Swing the hinge up and away
from the hinge pin on the door. Lift the door away from
the bottom hinge.
Re-assemble in reverse order.
When replacing the door ensure that the nylon hinge
bush is in position between the hinge pin and the hinge
bracket at the both the bottom and top.
14. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
15. To Change Oven Door Latch
Remove outer door panel
(see 14). Remove screws ‘B’
holding latch assembly to
inner door panel. Fit new
catch and reassemble in
reverse order.
Check correct door
operation.
16. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
17. To Change Oven Door Seals
Main ovens
Open oven door. The seal is held in place by small hooks
on the rear face. At the corner pull seal diagonally away
from the door centre until that hook is released. Proceed
to the next hook and release it in a similar way, and so
on. Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
Slow Cook Oven door seals
There are two parts to the door seal a top ‘gaol post’ part,
that can be unhook in a similar way to the main oven
seals, and a separate bottom seal.
To replace the door bottom seal the door must be
removed. Remove right hand side panel (see 3). Remove
the plinths and the central vertical cover (5 screws).
Remove the two countersunk screws (1 each side)
securing the hinge arms to the front of the chamber.
NOTE: The arms are spring tensioned. Carefully remove
the door. Retain the gaskets. The door bottom seal is
now accessible and can be unclipped and replaced.
Reassemble in reverse order ensuring that the gasket
is fi tted between the hinge arm and the front of the
chamber.
18. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from
grill roof, 2 screws and washers. Remove 2 screws
and washers securing the grill element front support.
Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from
the element terminals noting their position. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and remove
cover and disconnect the terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.