Rangemaster 110 - Manual (Page 40)

40
WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Top Element
Open the LH oven door and undo the fi xings that secure
the heat shield. Remove the top element bracket fi xings
and withdraw element. Replace the element and re-
assemble parts in reverse order. Check that the oven
operates satisfactorily.
24. To Remove a Slow Cook Oven Element
Remove the element cover fi xing screw and lift the cover
off the rear supporting screw.
Remove the screw holding the element to the rear of the
oven. Lift element out carefully, disconnect the terminals
connected to the element noting their positions. If it
is not possible to disconnect the leads in this way, pull
cooker forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and remove
cover and disconnect the terminals from the rear.
Fit new element, making sure that the element refl ector
is fi tted between the element and the oven side wall,
and reassemble in reverse order.
element refl ector
Check operation of oven.
25. To Replace the Ceramic Hob glass.
Remove the hotplate, see 2. Fit the replacement hotplate
and ceramic hob.
Reassemble in reverse order. Check operation of the
ceramic hob.
26. To Replace a Hob Element.
Remove the hotplate, see 2. The elements are now
accessible.
Reassemble in reverse order. Check operation of the
ceramic hob.
27. To change oven light bulb.
Turn off the power supply.
Make sure the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may
be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn
on the electricity supply and check that the bulb now
lights.
28 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fi xing screws and use the
notch and a fl at bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Eff ect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity