Radio Shack 28 - Manual (Page 11)

11
CONNECTIONS
Before using your Model 28 for the first time,
read through this entire section to determine
which connections best meet your needs. Then
follow the directions for completing the connec-
tions.
Notes:
• You can connect many different types of
audio/video systems such as a stereo
receiver/amplifier, a satellite receiver, or a
combination of a cable system and outside
antenna to your Model 28. These connec-
tions might require additional supplies that
are available from your local RadioShack
store.
• Disconnect power from the Model 28 when
making connections. Do not connect the
Model 28’s power cord (AC or DC) until you
complete all other connections.
CHOOSING A LOCATION
Choose a location for your Model 28 where:
• Air flows freely on all sides of the Model 28.
• The power cord (AC or DC) is not in the
way of normal traffic.
CONNECTING THE SUPPLIED
ANTENNA
Follow these steps to connect the supplied an-
tenna.
1. Insert the antenna’s post into the socket on
top of the Model 28’s cabinet.
2. Connect both sides of the antenna’s cable
to the supplied 300-to-75-ohm matching
transformer.
3. Plug the 300-to-75-ohm matching trans-
former into the Model 28’s ANT. terminal.
4. Fully extend the antenna and adjust it for
the best VHF reception.
Note: To improve UHF reception, shorten the
antenna.
AUDIO
VIDEO
IN
ANT.
OUT
IN OUT AUDIO
VIDEO
ANT.
AC
120V
DC 12V
16-420.fm Page 11 Tuesday, July 20, 1999 11:32 AM