Radio Shack 28 - Manual (Page 18)

18
Changing the Channels Stored in
Memory
Although the Model 28 automatically stores all
active channels in your area the first time you
turn it on, you can manually program the tuner’s
memory.
Note: If you tune both TV (broadcast) and CATV
(cable TV) signals, you can store both types of
channels.
1. Press MENU on the remote control to select
the main menu. The menu appears on the
TV screen.
2. Press 4 on the remote control to select
CHANNEL SET UP . The channel set up
menu appears on the TV screen.
3. Press 2 to select AUTO PRESET. The
Model 28’s tuner scans through the chan-
nels (TV or CATV) and stores all the active
channels in your area.
CH and the currently
tuned channel number appear on the TV
screen. After scanning all the channels, the
tuner stops on the lowest-numbered active
channel.
4. To review the saved channels, repeatedly
press CH or CH .
Note: You can directly select channels that are
not stored in the tuner’s memory by using the re-
mote control’s number buttons. See “Selecting
Channels” on Page 20.
Adding/Erasing Channels
If a channel you want was not stored, or if a
channel you do not want was stored, follow
these steps to add or erase it.
1. Press CH or CH or use the number
keys on the remote control to enter the
channel number you want to add or erase.
Note: Precede a single-digit number with a
0 – for example,
01 , 02 , etc.
2. Press MENU on the remote control to select
the main menu. The menu appears on the
TV screen.
3. Press 4 on the remote control to select
CHANNEL SET UP . The channel set up
menu appears on the TV screen.
4. Press 3 on the remote control to select
ADD/DELETE CH . The TV screen shows
ADD/DELETE CH , the currently tuned
channel’s number, and the input source (TV
or CATV).
5. Repeatedly press ADD/DELETE on the
remote control until the channel number for
the channel changes to blue (to add the
channel) or to red (to delete the channel).
6. Press MENU on the remote control to save
the changes.
SELECTING THE INPUT SIGNAL
Depending on the type of input device (antenna
or cable) connected to your Model 28, you must
select the input signal (the source you want the
Model 28 to tune).
1. Press MENU on the remote control to select
the main menu. The menu appears on the
TV screen.
2. Press 4 on the remote control to select
CHANNEL SET UP . The menu appears
on the TV screen.
23 ( TV )
ADD/DELETE CH
1 TV/CATV [ TV ]
2 AUTO PRESET
3 ADD/DELETE CH
- CHANNEL SET UP -
16-420.fm Page 18 Tuesday, July 20, 1999 11:32 AM