Radio Shack 28 - Manual (Page 36)

36
Dubbing a Tape
Note: For the best results while dubbing, hold
the remote control close to the Model 28’s infra-
red window when you press a button. Other-
wise, the remote control might affect the
dubbing source’s operation.
1. Prepare the dubbing source.
2. Insert a blank cassette, or one that you
want to record over, into the Model 28’s
cassette compartment. The Model 28 turns
on.
3. Enter 00 using the remote control’s number
buttons, or press CHANNEL or CHAN-
NEL to select one channel higher than
the highest programmed channel or one
channel lower than the lowest programmed
channel.
AUX appears on the Model 28’s
TV screen.
4. Repeatedly press SPEED on the remote
control until the desired recording speed
(
SP , LP , or SLP ) appears.
5. Press REC/OTR on the Model 28 or
RECORD on the remote control to begin
recording.
6. Start the dubbing source.
7. To turn off the Model 28’s TV screen, press
MONITOR .
8. Press STOP on the remote control or STOP/
EJECT on the front of the Model 28 to stop
recording before it automatically stops at
the end of the tape. Then stop the dubbing
source.
16-420.fm Page 36 Tuesday, July 20, 1999 11:32 AM