Radio Shack 28 - Manual (Page 32)

32
7. Use the number keys on the remote control
to enter the program’s start hour and
minute. For example, press
1 , 0 , 2 , and 8 to
set 10:28.
8. Press 1 or 2 on the remote control to select
AM (1) or PM . (2).
9. Repeat Steps 7 and 8 to enter the stop
hour and minute.
10. Use the number keys on the remote control
to enter the channel number. For example,
press
0 and 7 to set channel 7.
11. Press 1 ( SP ), 2 ( LP ), or 3 ( SLP ) on the
remote control to set the tape speed.
12. Double-check all the set information.
• If it is correct, press MENU to exit the
menu.
• If an entry is not correct, repeatedly press
SELECT to move forward or ADD/DELETE
to move backward to the incorrect entry,
use the number keys to enter the correct
information, then press
MENU . The Model
28 stores any settings you entered, and
the timer program screen disappears.
Notes:
• If you press ADD/DELETE after selecting
the program number (the program num-
ber flashes), the Model 28 clears the
timer program screen and deletes any
settings you entered.
• After you make a tape speed selection,
pressing SELECT causes the timer pro-
gram screen to disappear and stores any
settings you entered.
13. To store other programs, repeat Steps 2-
12.
14. Press POWER to turn off the Model 28. The
TIMER REC indicator turns on to indicate
that the Model 28 is in the timer standby
mode.
Important:
• You can turn on and operate the Model 28
manually prior to the set recording times,
but the Model 28 makes automatic timer
recording(s) only if the power is off at the
set start time(s).
• Be sure the TIMER REC indicator turns on
when you turn off the Model 28. If it does
not, check your programming.
• If you set up the Model 28 to record a CATV
program through a cable box, be sure to
leave the cable box turned on and tuned to
the correct channel before the timer pro-
gram starts.
Checking/Changing Automatic
Timers
1. Press POWER to turn on the Model 28.
2. Press MENU. The main menu appears on
the TV screen.
3. Press 1 on the remote control to select
TIMER PROGRAMMING . The timer pro-
gram screen appears on the TV screen.
4. Use the number buttons (1-7) on the
remote control to select the desired pro-
gram number, then press
SELECT .
5. Review all the displayed information.
• If it is correct, press MENU to exit the
menu.
• If an entry is not correct, repeatedly press
SELECT to move forward or ADD/DELETE
to move backward to the incorrect entry,
use the number keys to enter the correct
information, then press
MENU . The Model
28 stores any settings you entered, and
the timer program screen disappears.
PROG 1 2 3 4 5 6 7 8
DATE
START TIME
END TIME
CHANNEL
TAPE SPEED
16-420.fm Page 32 Tuesday, July 20, 1999 11:32 AM