RAD Data comm ASMi-31 - Manual (Page 15)

ASMi-31 Installation and Operation Manual Chapter 1. Introduction
16-03-00 15:51 Functional Description 1-3
1.2 Physical Description
ASMi-31 is available as a standalone desktop unit or as a card for the
ASM-MN-214 hub. Figure 1-2 shows the 3D view of the ASMi-31
standalone unit.
Figure 1-2 ASMi-31 Standalone Unit
The front panel includes eight LEDs, which display the status of power, data
flow, control signals and diagnostics. For detailed description of the front
panel, see Chapter 3, Operation.
The back panel includes an power connector with fuse, an interface
connector, and a terminal block with a ground connection for connecting
the telephone lines. The ASMi-31 rear panel is described in greater detail, in
Chapter 2, Installation and Setup.
The internal switches and jumpers can be configured to support a variety of
modes for operating the modem. Refer to Setting the Internal Jumpers in
Chapter 2 for details on jumper location and setting.
1.3 Functional Description
General The ASMi-31 standalone modem is managed by a master ASMi-31C modem
card mounted on a LRS-12 or LRS-24 hub. The management channel, which
is transmitted in-band, allows remote configuration, real-time alerts on
system failure, diagnostic testing, and the production of statistical
information on system performance.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com