RAD Data comm ASMi-31 - Manual (Page 63)

Installation of the ASMi-31 Unit in 19" Rack F-1
Appendix F
Installation in 19" Rack
F.1 Installation of the ASMi-31 Unit in 19" Rack
General The height of the unit is 1U (1.75"); the width of the unit is slightly less than
half the available mounting width. A rack adapter kit, RM-9, is available for
installing either a single unit or two units side by side in the 19" rack.
Warning
Disconnect the power before performing the procedures below.
Installation, operation, and maintenance of this unit should only be
performed by an experienced technician.
Installation of a
Single Unit Rack adapter components for installing a single unit include one short
bracket and one long bracket.
➤ ➤ ➤ ➤ To install a single unit:
1. Fasten each bracket to the side walls of the unit by two screws
which are inserted into the two front holes on the side wall. (The
unit is supplied with nuts already in place on the inner side wall).
Note that the short bracket fastens to the left side of the unit, and
the long bracket to the right side of the unit (see Figure F-1).
Once the brackets are fastened to the side walls, the unit is ready
for installation in the 19" rack.
2. Place the unit in the rack and fasten the brackets to the side rails of
the rack using two screws on each side (not included in the kit).
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com