Installation, 1 remote control, Notes on batteries – Runco CW-42HD User Manual
Page 23: Notes on remote control operation, Figure 3-1 . available range of the remote control, Remote control, 1. available range of the remote control, Pre l iminar y
Runco CinemaWall Owner’s Operating Manual
13
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control:
1.
Remove the battery cover from the back of the remote control.
2.
Insert the batteries included with the remote control. Ensure that the polarities
correctly match the
and
markings inside the battery compartment.
3.
Replace the battery cover.
If you have a CW-61 remote:
After a few seconds, the remote starts up automatically and
an Introduction screen appears. The remote control beeps twice to indicate that it has started
up successfully.
Notes on Batteries
• When installing batteries, make sure that the battery polarities are correct.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
The remote control can be used to control the CinemaWall within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
Approx.
7m / 23ft