Runco CW-42HD - Manual (Page 33)

Runco CinemaWall Owner’s Operating Manual 23
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Attach the two ferrite cores supplied with the display to each end of the AC power
cable as shown in Figure 4-1. Doing so will reduce radio frequency interference (RFI)
emissions to a level that conforms to FCC regulations. Use the supplied plastic bands
to secure the cores in place.
Figure 4-1. Attaching the Ferrite Cores to the Power Cable
3. Plug the female end of the power cord into the AC receptacle on the rear of the
CinemaWall (AC 100V ~ 240V). Connect the other end to your AC power source.
4. Press the POWER button on the underside of the CinemaWall. The power indicator
lights solid green.
5. After a brief warm-up period (approximately 10 seconds), the CinemaWall will display
an image.
4.2
Changing the OSD
Language The CinemaWall OSD language is initially set to English, but can also display the menus in
German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the
OSD language:
1. Press OK or MENU.
2. Select Install from the Main Menu.
3. Select Language from the Install Menu.
4. Press right- or left-arrow button ( or ) to highlight the desired language and press
OK or MENU. The change takes effect immediately.
4. Operation
Power cable
Ferrite Core
Ferrite Core