Runco CW-42HD - Manual (Page 44)

Operation
34 Runco CinemaWall Owner’s Operating Manual
PRE
L
IMINAR
Y
Audio To adjust the bass, treble and left/right balance, or to assign the CinemaWall audio inputs
to the video inputs, select Audio from the Main Menu and press OK or MENU.
Bass: To adjust the low-frequency response, select Bass from the Audio Menu and use
the left- and/or right-arrow buttons to adjust the amount of bass in the audio signal.
Treble: To adjust the high-frequency response, select Treble from the Audio Menu and
use the left- and/or right-arrow buttons to adjust the amount of treble in the audio signal.
Balance: To adjust the left/right speaker balance, select Balance from the Audio Menu
and use the left- and/or right-arrow buttons to make one channel louder than the other.
Audio Input 1/2/3: This menu lets you assign each audio input on the CinemaWall to a
video input. Doing so causes that audio signal to be heard through the speakers when the
associated video input is selected.
For example, if a DVD player’s video output is connected to the DVD/HD1 input on the
CinemaWall and its audio output is connected to audio input 2, select AUDIO INPUT 2
from the Audio menu. Then, use the left- and right-arrow buttons to assign it to DVD/HD1.
DVD/HD3 Input / DVD/HD4 Input: If you are using these inputs to connect an
HDMI-capable component, select HDMI to route the HDMI (digital) audio signal to the
speakers when DVD/HD3 or DVD/HD4 is selected.
Select INPUT 1-3 if the HDMI component’s analog audio out is connected to INPUT 1,
INPUT 2 or INPUT 3.
Image Options Use the controls in the Image Options menu to perform advanced image quality
adjustments and access various other CinemaWall features.
Aspect Ratio: To change the aspect ratio (size and shape) of the projected image, select
Aspect Ratio from the Image Options Menu and press OK or MENU. Select the
appropriate aspect ratio for the type of program material being viewed; refer to Table 4-1.
➤
BASS 0
TREBLE 0
BALANCE 0
AUDIO INPUT1 : VIDEO 1
AUDIO INPUT2 : DVD/HD 1
AUDIO INPUT3 : RGB
DVD/HD3 INPUT : HDMI
DVD/HD4 INPUT : HDMI
AUDIO
SEL. ADJ. RETURN EXIT
You cannot assign two or more audio inputs to the same video
input.
Note
➤
ASPECT RATIO : VRTWIDE
V SHIFT 0
H SHIFT 0
V-SIZE 0
H-SIZE 0
COMPUTER : OFF
FINE PICTURE 0
PICTURE ADJ 0
IMAGE OPTIONS
SEL. ADJ. RETURN EXIT
When you change the aspect ratio, save the change to a preset
afterwards. Otherwise, the change will be lost when a different
input is selected. (The aspect ratio is saved for each input and
resolution separately.) For information about saving settings, refer
to
Memory Setting on page 33.
Note