Runco VX-2000d - Manual (Page 18)

Controls and Functions
6 Runco VX-2000d Owner’s Operating Manual
PRE
L
IMINAR
Y
1. VERTICAL LENS SHIFT
Using a 9/64” hex wrench, turn this to move the lens up or down.
2. POWER LED
Lights red to indicate that the projector is in standby; flashes blue during warm-up or
cool-down or lights blue to indicate normal operation.
3. TEMP LED
Lights red to indicate that the projector has overheated and shut down.
4. INTAKE VENTS
Cool air enters the projector through these vents. To prevent overheating, ensure that
these vents are never blocked.
5. LAMP LED
Lights blue to indicate normal lamp operation; lights red if the lamp has failed.
6. EXHAUST VENTS
Hot air exits the projector through these vents. This air can be quite hot. Ensure that
there are no heat-sensitive objects near it and that it is never blocked.
7. ZOOM TAB
Turn this tab to make the projected image larger or smaller.
8. FOCUS RING
Turn this ring to focus the image.
9. RUNCO LOGO
You can rotate the logo to match the projector orientation: inverted (ceiling-mounted)
or upright. To rotate the logo, grip it at the sides, pull it away from the projector and
rotate it 180 degrees.
10. CABLE OPENING
Pass cables through this opening.
11. LAMP COVER
Remove this cover to access the lamp compartment.
12. REAR PANEL ACCESS DOOR
Open this door to access the rear-panel connectors and built-in keypad. To open the
door, push on the left side of the lever and rotate it 90 degrees clockwise. Then, pull
the lever toward you and down slightly.
1 2 3