Installation, 1 remote control, Battery installation – Runco VX-2000d User Manual
Page 29: Notes on remote control operation, Figure 3-1 . available range of the remote control, Remote control, 1. available range of the remote control, Pre l iminar y
Runco VX-2000d Owner’s Operating Manual
17
PRE
L
IMINAR
Y
3.1
Remote Control
Battery Installation
To install batteries in the remote control:
1.
Remove the battery cover from the back of
the remote control.
2.
Insert the batteries included with the remote
control. Ensure that the polarities correctly
match the
and
markings inside the
battery compartment.
3.
Replace the battery cover.
Notes on Remote Control
Operation
The remote control can be used to control the VX-2000d within the ranges shown in
Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
1. Do not mix an old battery with a new one or different types of
batteries.
2. If you will not use the remote control for a long time, remove the
batteries to avoid damage from battery leakage.
Note
Approx.
7m / 23ft